Tyro Sedna / Aquarius

By | January 6, 2020


Teaching in from the the Sedna transmitter to the Aquarius receiver. Make sure the Aquarius receiver is properly connected and provided with power supply Wire Number 1 on V+ Green/yellow on V- Switch on the Sedna remote control. In this case the system has not yet been programmed. Press the programming button on the bottom of the receiver. Press the ON key of the Sedna transmitter. Check the operation by pressing a button. Delete all transmitters from the memory Keep the programming button pressed in until the red LED goes off. Press the programming button again. Press the ON key of the Sedna transmitter. Check the operation by pressing a button.

Leave a Reply

Your email address will not be published. Required fields are marked *